Everything you need to know about Lil™ SOLID 2.0

lil SOLID 2.0 is an tobacco heating device, which allows 3 consecutive uses and provides the desired levels of nicotine with no ash, fire and smoke.

The device uses a stainless-steel pin and heats the Fiit sticks through induction, which ensures an even heating across the pin.

How to charge your device?

In order to fully experience the device, we recommend fully charging it by using the USB cable and AC power adaptor. When the device is being charged, the Status LED lights will light up.

Remember, that if the Status LED light blinks red, your device needs to be charged. If it blinks Orange, it means that the device is charged by 1-30%, Ice Blue indicates that the device is charged by 30-60% and the Blue light shows that the device is charged by 60-100%.

It takes approximately 2 hours to fully charge the device. Fully charged device enables three consecutive or 25 tobacco stick uses.

How to use lil SOLID 2.0?

lil SOLID 2.0 can recommended to be used with Fiit tobacco sticks.

Before using the device, it needs to be activated. In order to wake up the device press the Button for 2 seconds or connect the charger to the charging port. While the device wakes up, the Status LED blinks twice in red, orange, ice blue and blue, sequentially. Once the device is activated, the Status LED blinks in ice blue for one second and two vibrations occurs, simultaneously.

After the light stops blinking, insert a Fiit tobacco stick in the stick insertion part with the tobacco part facing down and press the stick in until it touches the bottom of the stick insertion part.

Now you can press the button for 2 seconds until vibration occurs. When the Status LED starts to blinks in ice blue, and vibration occurs, it shows that the device has started pre-heating the tobacco sticks. It will take around 25 seconds. When the preheating process ends, the Status LED lights will light up, and you will feel the vibration. This means that the preheating process has ended, and the device is ready for use.

Just remember, that single session lasts for 14 puffs or 5 minutes, whichever comes first. When the session is near to its end, you will feel two vibrations signaling the last remaining 30 seconds of the session or the last 3 puffs.

When the session comes to an end, the Status LED lights and the device will turn off automatically.

How to clean the lil SOLID 2.0?

For the best performance, we recommend cleaning the device after using 20 sticks. TO do so, remove the Cap from the device. Insert the Cleaning Wiper into the device and clean the device by spinning the Cleaning Wiper. Afterwards, insert the Cleaning Brush into the device and use it to clean remaining tobacco residue.

But that is not all! Lil SOLID 2.0 provides the automatic cleaning function. Just press the Button 5 times. You will see the Status LED lights blinking in orange, for 90 seconds. It indicates that the cleaning process will start automatically.

When the automatic cleaning process end, the Status LED lights will automatically go off, and you will feel vibration 2 times.